18 products
Strictly a blind cover for the PatchMODULE and CombiMODULE. Closes off non-equipped positions.
You can use the mounting plate to mount the SpliceMODULE, PatchMODULE or CombiMODULE as a stand-alone solution on the wall or in a street cabinet etc.
Can be mounted direct at the left side on the SpliceMODULE.
The mounting plate simplifies the introduction of loose tube, blow-in tubes and can be retrofitted on the SpliceMODULE.
Can be mounted between two SpliceMODULES.
The mounting plate simplifies the introduction of loose tube cables and can be retrofitted on the SpliceMODULE.
Up to 72 tubes with a diameter of Ø 5 mm can be hooked up without tools at the mounting plate on the SpliceMODULE and CombiMODULE.
The cable support plate is attached to one or both sides of the mounting plate to manage incoming and outgoing cables and blow-in tubes.
The overlength tray is used in loop installations and to take up the excess length of loose tube cables on the SpliceMODULE.
Suitable for the routing of breakout cables including strain relief on PatchMODULE. Can be mounted at the left or right side.
